If you're a Lego® fan and you may even have a new Lego sets with Lego® stickers, you know that those pesky stickers can be tough to remove. Worry no more! We will show you 7 effective ways to remove Lego® stickers without damaging your bricks or the box.
Warning: Patience is required!
Remove Lego® Stickers from a Box - 3 Options
1. Remove Lego® Sticker with a Hair Dryer
You will need:
- Hairdryer
- Dull knife
- Paper towel
Instructions:
- Heat the Lego® sticker with the use of a hair dryer that is set to the hottest setting for about 30 seconds to loosen up the glue under the sticker.
- Hold it close to the Lego® sticker until the sticker starts to bubble.
- Remove Lego® sticker by slowly pulling it off, starting on its edge.
- Use a dull knife or finger to gently scrape off any residue.
- Finally, wipe it off the box with a damp cloth.
2. Lighter Fluid to Remove Lego® Stickers Quick
You will need:
- Lighter Fluid (Low Odor)
- Paper Towel
Warning: Lighter Fluid is extremely flammable!
Instructions:
- Put a small amount of Lighter Fluid into the paper towel and rub it to the sticker.
- Slightly peel off the edge of the sticker using your fingernail until the sticker is completely removed. Repeat steps 1-2 for stubborn stickers.
- Clean off the box with a paper towel.
3. Remove Lego® Stickers With Alcohol
You will need:
- Cotton balls
- Rubbing Alcohol
- Dull knife
Instructions:
- Dip cotton balls in rubbing alcohol and place them against the Lego® sticker for a few seconds.
- To remove the Lego® sticker, insert the tip of the dull knife beneath the sticker.
- Slowly lift the edge of the sticker and peel it off until the sticker is completely removed.
- Wipe it off for any residue left on the box.
Remove Lego® Stickers Off the Bricks – The Easy Way!
1. Remove Lego® Sticker using Vaseline and a Hair Dryer
You will need:
- Vaseline
- Hairdryer
- Damp Cloth
- Dish Detergent
Instructions:
- Apply a generous amount of Vaseline to the Lego® sticker. (Make sure the sticker is completely coated.)
- Using a hair dryer, heat the coated part of the sticker. (We recommend placing the Lego® bricks on a piece of cloth when heating. The cloth will absorb the melted Vaseline.)
- To remove the Lego® sticker off the bricks, start on the edge of the sticker by lifting it up.
- Pull it off using your finger.
- Wipe any residue left on the Lego® bricks with a damp cloth.
2. Drinking Coffee and Remove Lego® Stickers?
You will need:
- Steaming Hot Mug
- Blade
- Damp Cloth
Instructions:
- Fill the mug with a steaming hot drink and press the Lego® bricks with the sticker against it.
- Roll the Lego® bricks back and forth for a few seconds until the sticker gets warm.
- Once the sticker glue starts to loosen, use the blade’s edge (or your finger) to carefully lift the corner of the Lego® sticker.
- Peel off the Lego® sticker using your fingers by gradually pulling it off. Repeat steps 1-4 to completely remove the Lego® sticker.
- Finally, wipe off any glue residue left on the bricks with a damp cloth.
3. Goo Gone to Remove Lego® Sticker Away!
You will need:
- Dull Knife
- Toothbrush
- Goo Gone (adhesive remover)
- A damp cloth or paper towel
Instructions:
- To remove Lego® sticker from the bricks, take a dull knife or your finger to lift the edge of the sticker.
- Peel it off with your finger until you have completely removed it.
- Use a toothbrush to scrub any bits of glue residue clinging to the brick.
- Dab a small amount of Goo Gone on areas with hard-to-remove residue. Let it sit for a couple of minutes.
- Finally, wipe it off with a damp cloth and paper towel.
4. Remove Lego® Sticker Easily with a Paint Thinner!
You will need:
- Dishwashing detergent
- Paint thinner
- Paper towel
- Tub of water
- Dull knife
Instructions:
- Using your fingernail or a dull knife, remove Lego® sticker by pulling it from its edge.
- Take a paper towel and fold it several times, and pour a fair amount of paint thinner into the paper towel.
- Rub off any glue residue with a paper towel that has a paint thinner on it until the residue is completely gone.
- Immediately soak the Lego® bricks in a tub of water to remove the paint thinner.
- Take the Lego® bricks out of the tub and transfer them to a second tub with a diluted dishwashing detergent. Soak it for about 20 minutes.
- Clean off Lego® bricks with water, then dry them with a clean towel.
Conclusion
There you have it! Safe and effective ways to remove those pesky Lego® stickers without damaging your Lego® bricks or the box. So next time you make a quick switch, you'll know what to do. Part of the process is patience, but eventually, you’ll get through it. Also, If you want to add more Lego® sets, be sure to check out the Lego® deals and Lego® Sets for Adults for great gift ideas
Are you planning to add more to your collection at the best price? Brickfact app helps you find the best price for Lego® sets so you can buy them at a low cost from a list of sellers. The Brickfact app informs you via push notification as soon as a new Lego® deal is available. The Brickfact app is free and available for both iOS and Android.